Home » Gigabyte Reset Instructions » Acer beTouch E100 Hard Reset

Acer beTouch E100 Hard Reset

Master Reset Instructions


These instructions will help you master reset your phone, if you are unable to master reset your phone or you have a device that does not run on operating system then continue on below

Acer beTouch E100 Hard Reset

Before you give your handset to repair shop or buy new handset, please try the following procedure to repair your device. First charge your battery more then 70%, backup your important data like phone-book, message, email, images and settings and in most cases take out SIM card and SD card. After doing hard reset not possible to recover your data, so online backup is always important. For all of your data, a backup should be done on a external device, hard drive, raid system media or SD card.

How to Hard Reset Acer beTouch E100

Hard Reset Acer beTouch E100 Smartphone You may have to execute a reset if your Acer beTouch E100 Smartphone fails to answer when control buttons are pressed tapped.

Note: Just before performing a reset, make sure that your Acer beTouch E100 Smartphone is not locked. Click any key or tap the display screen to see if the finger print out display screen opens.

Soft Reset: Resetting will restart and clear the Ram of your Smartphone. It is similar to turning a Pc off and then turning it back on.

Important note: To reduce risking destruction to your Acer beTouch E100 Smartphone, only use the supplied stylus to reset the device. Using the tip of your stylus, lightly click the Reset key inside the hole on the side of your Acer beTouch E100 Smartphone.

Acer beTouch E100 Clean boot

Note:You must only execute a fresh boot when all other reset choices have failed to recover your Acer beTouch E100 Smartphone to an functional state.

A clean boot will recover your Acer beTouch E100 Smartphone to the state it was when you got it from the factory.

Note: delete all information, any connections stored on your smartphone and any applications you set up.

If your display screen is replying to stylus input:

  • Go to Start
  • Then go to Programs
  • Then go to Utilities
  • Then go to Default Configurations. Read the notice information and enter the security code in the clear text box. Tap OK to continue

If your display screen is not replying to stylus input:

  • Slide the Silent switch to Off (turn on the sound).
  • Press and hold the Camera button Camera. Without releasing it, Press and Release the Reset button Reset.
  • Continue to hold the Camera button until you see the message Clean Boot.
  • Press the Home button to continue.


, , ,