Acer N20 Hard Reset
Master Reset Instructions
CLICK ON YOUR RESPECTIVE DEVICES OPERATING SYSTEM
These instructions will help you master reset your phone, if you are unable to master reset your phone or you have a device that does not run on operating system then continue on below
Acer N20 Hard Reset
Before you give your handset to repair shop or buy new handset, please try the following procedure to repair your device. First charge your battery more then 70%, backup your important data like phone-book, message, email, images and settings and in most cases take out SIM card and SD card. After doing hard reset not possible to recover your data, so online backup is always important. For all of your data, a backup should be done on a external device, hard drive, raid system media or SD card.
How to Hard Reset Acer N20
Acer N20 Reset may be set to reset the device if it does not respond to the on-screen button is touched. Performing a soft reset A soft reset allows your Acer N20 Series system like the computer is restarted. After a soft reset is maintained all records and entries.
Soft reset: Using the tip of your stylus, lightly press the reset button inside the hole on the rear panel of your handheld.
A hard reset will erase all records and entries stored in your handheld. Never performs hard reset unless a soft reset does not correct your problem. When you perform your next Active Sync operation, you can restore any data that you previously synchronicity your computer. To perform a hard reset, do the following:
- Detach the battery pack from your handheld.Refer to To uninstall the battery pack on page 9 for instructions.
- Slide up the hard reset switch located on the right side of the battery bay (a) then slide it down again (b).
- After resetting your handheld, reinstall the battery pack in its bay.Refer to To install the battery pack on page 8 for instructions.
Note: When you perform a hard reset, the current date and time are retained. Formats,preferences, and other settings are restored to their factory default settings
