Home » Acer Reset Instructions » Acer beTouch E200 Hard Reset

Acer beTouch E200 Hard Reset

Master Reset Instructions


These instructions will help you master reset your phone, if you are unable to master reset your phone or you have a device that does not run on operating system then continue on below

Acer beTouch E200 Hard Reset

Before you give your handset to repair shop or buy new handset, please try the following procedure to repair your device. First charge your battery more then 70%, backup your important data like phone-book, message, email, images and settings and in most cases take out SIM card and SD card. After doing hard reset not possible to recover your data, so online backup is always important. For all of your data, a backup should be done on a external device, hard drive, raid system media or SD card.

How to Hard Reset Acer beTouch E200

Use the tip of your stylus to lightly press the Reset button inside the stylus holder. A reset will clear the RAM of your smartphone. It is similar to turning a computer off and then turning it back on.

When all other reset options have failed to restore your smartphone to an operational state, you should only perform a clean boot. A clean boot will restore your smartphone to the factory settings. This will erase all your personal information, any contacts stored on your phone and any programs you installed.

If your screen is responding to stylus input:

  • Tap Start,
  • Tap Utilities and then,
  • Tap Default Settings.
  • Read the warning information and enter the security code in the empty textbox. Tap OK to proceed.

If your screen is not responding to stylus input:

  • Press the Reset button then,
  • Press Power, Call button and End button at the same time.

Note: During the procedure a hard reset (Hard Reset) on the Acer beTouch E200 all of your personal data (contacts, photos, music, etc.) will be deleted. Be sure to pre-make a backup copy of your personal data!

Before you make a Hard Reset Acer beTouch E200, the memory card is better to remove from the device

(if any).


, ,